![]() ![]() This is what really threw me in the assembly. I’ll have a pict in a day or 2, heading out tomorrow for more kerosene for the shop heater, then I’ll draw on the board where/how I’m planning on extending the waste board screwdown slots. So right now I’m still trying to identify what i did wrong since when the gantry is rolled all the way to the front, the right side touches the support and the left side has a gap if say half inch, when gantry rolled all the way to the rear the right side has the gap and the leftside touches the support. I’m in iowa and it’s friggin cold here right now, and using my torpedo kerosene heater is a bit harsh on the eyes. And as i found out the support from Inventables IS everything a person could ask for and more. Ok it’s early in the am for me so i might be wrong.Īlso im building versin 2.0 of the x-carve. There was a diff in size the inventables was a bit bigger. And whaaat? There was already an x-carve PostP in inches and millimeters. ![]() So I’m now upgraded on vcpro to 8.5.Īs a side note, i was tracking down the location to put in the x-carve postprocessors. All is resolved, 24 hours later when i fired up the program again it then popped up with the Registration window where she was then allowed to register the software in my name. Of course I totaly forgot about this thread. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |